![]() I tried it on my Linksys video stream and it works great-about 17 frames per second with the Linksys set at Normal quality, 320x240 resolution and 30 fps. KB/ audio- video/ Motion_ Detection.aspx I also tried every possible speed, quality and resolution setting on the Linksys control panel with no luck-RoboRealm always seems to get the video stream at around 7 fps or less. Unfortunately that did not fix my problem. It works for me but I have no idea why? (Buffer issues or ?) Something quick to try: I have noticed that when I set the frame rate to 30 in roborealm recently, (on a variety of networked cameras) the pipeline slows down to about 7fps.(This didn't happen on older versions (from about 3 months ago or so.) Try setting the framerate in roborealm to 20 fps and see if things improve. ![]() Here is the relevant piece of javascript when doing a "view source" in the Linksys web based viewer: The URL I am using in RR is img/ mjpeg.cgi and even with the Refresh Frequency set to ASAP, the fastest frame rate I see is 7 fps and the video is noticeably slower than when viewing through the Linksys interface.ĭo you have any suggestions on how I can get a better refresh rate in RR? If I view the video within the Linksys web-based application, the motion looks smooth and fast-but this uses some javascript code to display the video (see below). I set up the Linksys camera for Normal quality and 30 fps max at 320x240 resolution for both MPEG-4 and MJPEG. The video looks smooth and fast in both IE and Firefox, but the best I can get in RoboRealm running on the same computer is about 7 fps. The trouble I am having is slow frame rates in RoboRealm even without any processing. I'm back to playing with the Linksys WVC54GCA wireless IP camera and the Read_HTTP module in RR 2.0.5.1. You guys rock! I had tried that alternate form of the URL earlier without success but now with RR 1.8.23.36 it works perfectly. Can you try to redownload and see if this helps your situation? This has been fixed and uploaded in 1.8.23.36. Nevertheless, there was a small problem even with this one that caused RR to not grab the image correctly. I tried copying these into the RoboRealm "Additional HTTP Headers" box in the Read_HTTP module, but that didn't fix it.ĭo you have any suggestions how I might find the right URL to work with RoboRealm? Or perhaps the right additional HTTP headers? Occasionally however, I can get the image to freeze this way and then a "View Page Source" shows the following lines at the top of the binary image data: The image "" cannot be displayed because it contains errors. If I click the "Stop" button on the browser, I get the error message: One clue is that the above URL causes the web browser (Firefox) to continually refresh. I have the same problem with or without authentication. ![]() The URL to the motion jpeg works fine if I just copy and paste it into my browser's location box:īut when I use the same URL in the RoboRealm Read_HTTP module, I do not see an image after clicking the Start button (Refresh is set to ASAP). I just picked up a wireless Linksys WVC54GCA IP camera. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |